News

How to maintain the zirconia ceramic dispensing valve？

Zirconia ceramic material has its own lubrication effect, so there is a great breakthrough in the dispensing valve mating parts, zirconia ceramic dispensing valve built-in buffer compensation elastic gasket to ensure stable and good sealing, so zirconia ceramic dispensing valve should be how to maintain it?

The thickness of ceramic dispensing valve shell exceeds the standard data requirements of GB, JB and ANSI, the chemical elements and mechanical properties of the main material meet the requirements of the specified standards, the shell has a three-section structure design, solid body shape and beautiful appearance.

First, use a wrench to unscrew the inlet connector, clean the inlet connector, use a wrench to unscrew the outlet connector, after unscrewing, you will see a top bar in the material cylinder.

Use a screwdriver to turn the top rod counterclockwise (note that there are two small nuts on the top rod to fix the position of the top rod), then pull out the top rod, remove the white gasket, clean the cylinder, and then put the white gasket in.Screw in the top rod (note that there are two small nuts fixing the top rod position), not too tight and not too loose when screwing in, make sure there is no glue leakage here when using, then screw in the glue outlet connector, if the white gasket is worn or deformed, replace the white gasket in this position.If there is a drip of glue or lock glue can not be, you can turn out the glue outlet connector, rotate the top rod upward, the magnitude of the rotation is not too large, and then screw the glue outlet connector.